summaryrefslogtreecommitdiffstats
path: root/resources/grub
diff options
context:
space:
mode:
Diffstat (limited to 'resources/grub')
-rw-r--r--resources/grub/config/menuentries/common.cfg17
1 files changed, 5 insertions, 12 deletions
diff --git a/resources/grub/config/menuentries/common.cfg b/resources/grub/config/menuentries/common.cfg
index 9e5c04e..95599df 100644
--- a/resources/grub/config/menuentries/common.cfg
+++ b/resources/grub/config/menuentries/common.cfg
@@ -24,25 +24,20 @@ menuentry 'Load Operating System (incl. fully encrypted disks) [o]' --hotkey='o
# GRUB handles (almost) every possible disk setup, but only the location of /boot is actually important,
# since GRUB only loads the user's config. As soon as the kernel takes over, libreboot's done.
-# RAID, filesystems and encryption on both raw devices and partitions in all various combinations
+# filesystems and encryption on both raw devices and partitions in all various combinations
# need to be supported. Since full disk encryption is possible with GRUB as payload and probably desired/used
# by most users, libreboot GRUB config tries to load the operating system (kernel) in the following way:
- # 1. Try to decrypt raw devices first. This <your disk setup> inside a LUKS container is pretty common
- # a) Try RAID first, they might be used (accross multiple (raw) devices)
- # b) Try MBR/GPT partitions at last, one might still conviniently uses a single partition
+ # Try to decrypt raw devices first. This <your disk setup> inside a LUKS container is pretty common
# prompt user for passphrase if LUKS header is found
- for d in md/0 ahci0; do cryptomount ${d}; done
- for j in 1 2 3 4 5 6 7 8 9; do cryptomount "ahci0,${j}"; done
-
- # (This way, we only need to scan for encrypted data once while covering every possible disk setup,
- # be it BTRFS/ZFS/ext4/etc. (on LUKS) (on RAID) on/across raw devices/MBR/GPT
+ cryptomount ahci0
+ for j in 1 2 3 4 5 6 7 8 9; do cryptomount ahci0,${j}; done
# 2. Look for user config. If the above routine successfully decrypted a LUKS container, its content
# will be searched before everything else for obvious reasons. Regardless of this, the devices'
# hirachy stays the same.
- for d in crypto0 md/0 ahci0; do switch_to_grub_config ${d}; done
+ for d in crypto0 ahci0; do switch_to_grub_config ${d}; done
for j in 1 2 3 4 5 6 7 8 9; do
for d in crypto0 ahci0; do switch_to_grub_config "${d},${j}"; done
done
@@ -52,8 +47,6 @@ menuentry 'Load Operating System (incl. fully encrypted disks) [o]' --hotkey='o
if [ $? = 0 ]; then
kf="-k (${kf})/keyfile ${d}"
fi
- # (This way, we only need to scan for encrypted data once while covering every possible disk setup,
- # be it BTRFS/ZFS/ext4/etc. (on LUKS) (on RAID) on/across raw devices/MBR/GPT
for d in ${devs}; do
cryptomount ${kf} ${d}
done