From 49887958b2d18f12197871974a9ae957adfe3c0b Mon Sep 17 00:00:00 2001 From: Francis Rowe Date: Sun, 15 Feb 2015 03:52:04 -0500 Subject: docs/install/x200_external.html: Show images, don't link. --- (limited to 'docs/install') diff --git a/docs/install/x200_external.html b/docs/install/x200_external.html index 8c1df7e..b3de46b 100644 --- a/docs/install/x200_external.html +++ b/docs/install/x200_external.html @@ -94,24 +94,22 @@ POMONA 5250 (correlate with the BBB guide) 3.3V PSU RED - - 17 - this is pin 1 on the flash chip. in front of it is the screen. === right side of the X200 (where the audio jacks are) === This is how you will connect. Numbers refer to pin numbers on the BBB, on the plugs near the DC jack. -Here is a photo of the SOIC-8 flash chip: images/x200/soic8.jpg -(image copyright 2015 Patrick "P. J." McDermott <pj@pehjota.net>, CC BY-SA 3.0 or later) +Here is a photo of the SOIC-8 flash chip:
+freenode IRC #libreboot 01:42 UK/London timezone February 8th 2015: pehjota: fchmmr: Here are two photos in the camera's configured resolution; resize them as you wish: http://www.pehjota.net/~pj/x200/soic-8/. License: CC BY-SA 3.0 or later. If you want other angles or anything, let me know. Look at the pads in that photo, on the left and right. Those are for SOIC-16. Would it be possible to remove the SOIC-8 and solder a SOIC-16 chip on those pins?

On the X200S the flash chip is underneath the board, in a WSON package. - The pinout is very much the same as a SOIC-8, except you need to solder (there are no clips available). - images/x200/wson_soldered.jpg (image copyright (C) 2014 Steve Shenton under CC-BY-SA 4.0 - or higher, same license that this document uses) shows it wired (soldered) and - connected to a BBB. + The pinout is very much the same as a SOIC-8, except you need to solder (there are no clips available).
+ The following image shows how this is done:
+
In this image, a pin header was soldered onto the WSON. Another solution might be to de-solder the WSON-8 chip and put a SOIC-8 there instead. Check the list of SOIC-8 flash chips at ../hcl/gm45_remove_me.html#flashchips but do note that these are only 4MiB (32Mb) chips. The only X200 SPI chips with 8MiB capacity are SOIC-16. For 8MiB capacity in this case, the X201 SOIC-8 flash chip (Macronix 25L6445E) might work. -
Another possible solution: ground GPIO33 and boot up in non-descriptor mode. This might make software flashing possible, if it's possible to circumvent any flashing protections that might exist.

@@ -120,9 +118,8 @@ chip on those pins? Connect Pomona 5252/5250 to the X200 flash chip, and dump/flash

- images/x200/x200_pomona.jpg - shows everything connected. In this picture, the X200 is being flashed - with the BBB. + The following photo shows an X200 flashed using the BBB:
+

Remove the battery from your X200, then remove all the screws on -- cgit v0.9.1