diff options
Diffstat (limited to 'docs/install/bbb_setup.html')
| -rw-r--r-- | docs/install/bbb_setup.html | 11 |
1 files changed, 6 insertions, 5 deletions
diff --git a/docs/install/bbb_setup.html b/docs/install/bbb_setup.html index e6b99a2..ebcc7d2 100644 --- a/docs/install/bbb_setup.html +++ b/docs/install/bbb_setup.html @@ -294,7 +294,7 @@ Note: flashrom can never write if the flash chip isn't found automatically. NC - - NC NC - - NC NC - - NC - 18 - - 3.3V PSU RED + 18 - - 3.3V (PSU) 22 - - NC - this is pin 1 on the flash chip <i>This is how you will connect. Numbers refer to pin numbers on the BBB, on the plugs near the DC jack.</i> @@ -320,7 +320,7 @@ MISO 8-9 WP 18 - - 1 22 - - NC NC - - 21 - 3.3V PSU RED - - 17 - this is pin 1 on the flash chip + 3.3V (PSU) - - 17 - this is pin 1 on the flash chip <i>This is how you will connect. Numbers refer to pin numbers on the BBB, on the plugs near the DC jack.</i> You may also need to connect pins 3 and 7 (tie to 3.3V supply). These are HOLD# and WP#. @@ -338,11 +338,12 @@ GND 4-5 MOSI <b>NC = no connection</b> </p> <p> - <b><u>DO NOT</u> connect 3.3V PSU RED yet. ONLY connect this once the pomona is connected to the flash chip.</b> + <b><u>DO NOT</u> connect 3.3V (PSU) yet. ONLY connect this once the pomona is connected to the flash chip.</b> </p> <p> - <b>You also need to connect the BLACK wire from the 3.3V PSU to pin 2 on the BBB (P9 header). It is safe to install this now - (that is, before you connect the pomona to the flash chip).</b> + <b>You also need to connect the BLACK wire (ground/earth) from the 3.3V PSU to pin 2 on the BBB (P9 header). + It is safe to install this now + (that is, before you connect the pomona to the flash chip); in fact, you should.</b> </p> <p> if you need to extend the 3.3v psu leads, just use the same colour M-F leads, <b>but</b> keep all other |