From f6af937275b327a6337dbf535128cd65c028aa43 Mon Sep 17 00:00:00 2001
From: Patrick McDermott <patrick.mcdermott@libiquity.com>
Date: Fri, 18 Oct 2019 23:53:13 -0400
Subject: Revert "Base: Reduce layer height to 0.2 mm"

This reverts commit ab84e54274cf87f575ff1436b064ac52df3f9ad9.

The higher number of perimeter layers and lower number of infill layers
almost balance each other out in print time.  Layer seams are similar as
well; if anything, the 0.2-mm seams protrude more.
---
diff --git a/.Slic3r/print/Base.ini b/.Slic3r/print/Base.ini
index 8ae8306..d7cff46 100644
--- a/.Slic3r/print/Base.ini
+++ b/.Slic3r/print/Base.ini
@@ -1,4 +1,4 @@
-# generated by Slic3r 1.2.9 on Fri Oct 18 23:28:52 2019
+# generated by Slic3r 1.2.9 on Fri Oct 18 22:42:49 2019
 avoid_crossing_perimeters = 0
 bottom_solid_layers = 2
 bridge_acceleration = 0
@@ -21,7 +21,7 @@ fill_density = 20%
 fill_pattern = rectilinear
 first_layer_acceleration = 0
 first_layer_extrusion_width = 0
-first_layer_height = 0.2
+first_layer_height = 0.25
 first_layer_speed = 100%
 gap_fill_speed = 40
 gcode_comments = 1
@@ -34,7 +34,7 @@ infill_only_where_needed = 0
 infill_overlap = 0
 infill_speed = 100
 interface_shells = 0
-layer_height = 0.2
+layer_height = 0.25
 max_print_speed = 80
 max_volumetric_speed = 0
 min_skirt_length = 5
--
cgit v0.9.1